AVF TP800-XL - Manual (Page 5)

M6 x 12
(6)
6mm Hex Key
(1)
On Single displays after TV
is hung.Lift this lock into its
top position and secure with
M8 Bolt from
underneath.
 
The rack mounted basket
can be removed to mount
a rack mountable codec
Power Cord
VIDEO FURNITURE INTERNATIONAL
190 Don Hillock Drive Aurora , Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 1-905-751-1488 Local:905-751-1459
Page 5
of 5
Step 7
1) Make sure all electronics are
connected and run the power bar
cable out the bottom of the stand .
Re-install the back cover.
Your Done!
Step 6
1) Run all cables from the codec
through the front grommets.
2) Slide TV with attached brackets
onto the installed TV bar.
3) If the camera needs to be
lowered, loosen the camera bracket
nuts with a 1/2" wrench while
holding the camera with your other
hand to prevent it from falling. You
can then slide the camera to rest on
top of TV and re-tighten the nuts.
If inputs are located on the back of the
TV, connect the cables to the TV
before mounting. (requires two people)
Installing Covers
Mounting TV