Bradford White ACCESSORY PACKAGES - Manual (Page 10)

Remote Mounting the Setback Control
-10-
Prepare the Backplate for Wiring
Step 3: Loosen the (3) slotted screws on the backplate attached to the Setback Control Junction Box
Assembly. This is shown in Figure 9.
Mount the Protective Plate
Step 4: Mount the Setback Control Protective Plate in a desired location. Be sure that the Setback
Control will not be direct sunlight, as the display may be difficult to read. This is shown in Figure 10.
Figure 10
Drill
Protective
Plate
Wall
Figure 9
Backplate (already
installed)
Setback Control
Junction Box
Assembly
Slotted head
screwdriver
Slotted head
screws