Home Styles 9200-1211 - Manual (Page 2)

Assembly Instructions 2/3
STEP 1
STEP 2
STEP 3
Tighten Head
Cap Bolt by
Hex Wrench.
B
D
H
E
E
M
F
O
I
J
G
C
C
G
D
Attach four Casters to the Base (J) with
Wood Screws.
(See the ‘Arrow’ sticker indicating front area
on the base.)
Slide the Back Panel (E) and (F) in places.
Attach the Back Stretcher (H) and Front
Stretcher (I) to the unit with Head Cap Bolts
through the Side Panel (D).
Tighten Head Cap Bolts half way.
Attach the Drawer Divider (M) in between
the Back Stretcher (H) and Front Stretcher
(I), using Head Cap Bolt.
Attach the Side Panel (B) to the unit, using
Head Cap Bolts.
Tighten up all Head Cap Bolts.
Attach the Towel Bar (O) to the Side Panel (D), using Head Cap Bolts (short).
Attach the Side Panel (D) to the Base (J).
Tighten Head Cap Bolt only half way.
Attach the Back Piece (G) to the Base
and the Middle Panel (C) to the Back Piece (G).
IMPORTANT
Do not tighten up all the screws until each part is properly assembled.
You should keep Hex Wrench in the safe place as you may need to
tighten up the Head Cap Bolts in the future.
Head Cap Bolt
Locking Casters
Head Cap Bolt
(short)
Head Cap Bolt
Head Cap Bolt