Industrial Injection 6.7L Dodge Cummins Compound Turbo - Manual (Page 9)

15. INSTALL NEW RUBBER BOOT AND CLAMPS FROM STOCK TURBO TO NEW TUR-
BO. NOW TIGHTEN THE COMPRESSOR HOUSING CLAMP. RUBBER BOOT IS LONG
AND NEEDS TO BE CUT TO FIT. USE THE SUPPLIED CLAMPS AS A STRAIGHT EDGE
TO CUT RUBBER BOOT TO FIT.
16. INSTALL STEEL BRAIDED OIL DRAIN LINE. NOTE: CUT TO LENGTH, SO THERE IS NOT
KINKS BUT ENOUGH SLACK FOR MOTOR FLEX
CLAMP WILL ALLOW YOU TO CUT A
STRAIGHT LINE, CUT IN STEPS FOR
PROPER FIT.
8.