Industrial Injection LBZ/LMM Duramax Compound Turbo - Manual (Page 8)

24. Install the engine breather tube cut off both sides if the breather tube 1’’ from the bolt hole and connect
¾’’ hose using clamps and fitting and use factory bolts and install back on engine.
CUT HERE
CUT HERE
RUNS TO THE
BOTTOM OF TRUCK
25. We recommend you drain the oil and put new oil in the truck after you drilled and tapped the oil pan.
Install remaining heat shield on the inner fender were the turbo will be. (Note: if turbo is rubbing fender
wall use a heat gun to heat up plastic and push away from turbo housing. Put heat shield on fender.)