M2tech, Front panel – M2TECH Palmer User Manual
Page 6
PALMER POWER STATION
LOW NOISE BATTERY POWER SUPPLY/CHARGER
REVISION P
r
B – DECEMBER 2011
Copyright © 2011, M2Tech Srl
6
M2Tech
www.m2tech.biz
2. Front Panel
1
2
3
4
1) Mains switch. Push to apply mains power to the PALMER POWER STATION. Depending on
the status of the output switch (item 2) and the battery charge level, switching power on
may start battery charge. Also, charge may be terminated at any time by switching power
off. Please see Section 5 for the effect of this switch status over battery charge start policy.
2) Output switch. Enables and disables both outputs. It’s useful to switch powered units
off by this switch when not listening to music to save battery charge and avoid undesired
charge cycles, thus increasing battery life. Please see Section 5 for the effect of this switch
status over battery charge start policy.
3) Power indicator. A red led glows when the mains switch (item 1) is on.
4) Charge indicator. A red led glows when charge is in progress.