Magnum Dynalab MD-108T - Manual (Page 9)

- 9 -
TUNER REMOTE (OPTIONAL)
If your tuner was ordered with the RC2 “PRECISION REMOTE SYSTEM”, please
reference the following operating instructions.
1. The power switch should be off on the front panel of the tuner
2. Using the remote handheld, push the “POWER ON” button. You will see the
tuner turn on. YOU MUST TURN THE POWER ON MANUALLY ON THE
FRONT PANEL TO TUNE IN MANUAL MODE. IF YOU TURN THE POWER
ON WITH THE REMOTE CONTROL YOU WILL BE IN REMOTE TUNER MODE.
3. To tune with the handheld, push and then hold either the “TUNE UP” or
“TUNE DOWN” button until you reach the desired station. The longer you
hold the button the faster the frequency changes. To FINE TUNE hold either
button for a shorter time until your center tune meter is set or your magic
eye tube is closed.
4. Your Precision remote gives you the ability to store and scan up to 20
preset stations. To program a preset station, first tune to the desired
station and then push “STORE”. Then select the preset memory position you
want to store this station in by selecting two digits. For Presets 1-9 you
must select 01-09 and for 10+ directly enter the number. To recall these
presets you must push “PRESET” and then enter the two-digit preset you
wish to recall.
*NOTE-When setting a preset you must enter the numbers quickly
5. To turn your tuner off, push the “POWER OFF” button until you see the
tuner turn off. YOU MUST TURN THE POWER OFF ON THE FRONT PANEL
IN MANUAL MODE AND FROM THE REMOTE CONTROL IN REMOTE MODE.
Your MDR remote operates with 3 AAA batteries, which are included.