Magnum Dynalab MD-108 - Manual (Page 9)

9
TUNER REMOTE (OPTIONAL)
If your tuner was ordered with the MDR “PRECISION REMOTE SYSTEM”, here are the
operating instructions.
1. The power switch should be off on the front panel of the tuner
2. Using the remote handheld, push the “POWER ON” button. You will see the tuner turn
on. IF YOU HAVE THE MD 108 TUNER YOU MUST TURN THE POWER ON
MANUALLY ON THE FRONT PANEL TO TUNE IN MANUAL MODE. IF YOU
TURN THE POWER ON WITH THE REMOTE CONTROL YOU WILL BE IN
REMOTE TUNER MODE.
3. To tune with the handheld, push and then hold either the “TUNE UP” or “TUNE
DOWN” button until you reach the desired station. The longer you hold the button the
faster the frequency changes. To FINE TUNE hold either button for a shorter time until
your center tune meter is set or your magic eye tube is closed.
4. Your Precision remote gives you the ability to store and scan up to 20 preset stations. To
program a preset station, first tune to the desired station and then push “STORE”. Then
select the preset memory position you want to store this station in by selecting two digits.
For 1-9 you must select 01-09 and for 10+ directly enter the number. To recall these
presets you must push “P” and then enter the two-digit preset you wish to recall.
*NOTE-When setting a preset you must enter the numbers quickly
5. If you want to scan through your favorite preset stations simply push “PRESET UP” or
“PRESET DOWN” and you will sequence through the stations.
6. To turn your tuner off, push the “POWER OFF” button until you see the tuner turn off.
IN THE CASE OF THE MODEL 108 YOU MUST TURN THE POWER OFF ON
THE FRONT PANEL IN MANUAL MODE AND FROM THE REMOTE
CONTROLIN REMOTE MODE.
Your MDR remote operates with 3 AAA batteries, which are included.