Magnum Dynalab MD-90 - Manual (Page 9)

- 9 -
TUNER REMOTE (OPTIONAL)
If your tuner was ordered with the RC1 “PRECISION REMOTE SYSTEM”, here are
the operating instructions.
1. The power switch should be off on the front panel of the tuner
2. Using the remote handheld, push the “POWER ON” button. You will see the
tuner turn on.
3. To tune with the handheld, push and then hold either the “TUNE UP” or
“TUNE DOWN” button until you reach the desired station. The longer you
hold the button the faster the frequency changes. To FINE TUNE hold either
button for a shorter time until your center tune meter is set or your magic
eye tube is closed.
4. Your Precision remote gives you the ability to store and scan up to 20
preset stations. To program a preset station, first tune to the desired
station and then push “STORE”. Then select the preset memory position you
want to store this station in by selecting two digits. For numbers 1-9 you
must select 01-09 and for 10+ directly enter the number. To recall these
presets you must push “P” and then enter the two-digit preset you wish to
recall. *NOTE-When setting a preset you must enter the numbers quickly.
5. To turn your tuner off, push the “POWER OFF” button until you see the
tuner turn off.
Your RC1 remote operates with 2 AA batteries, which are included.