Magnum Dynalab MD-307 - Manual (Page 7)

- - 7
SET UP THE MD 307 HYRBID INTEGRATED AMPLIFIER WITH AN EXTERNAL HOME
THEATER PROCESSOR
The MD 307 Hybrid Integrated Amplifier is equipped with a unity gain input (A3/SSP
Mode Input on the Pre-Amplifier section). This is a switchable input, meaning the
input can be used as a normal pre-amplifier input or in unity gain mode.
To Connect to a Home Theater Processor
1. Turn all the power off to the MD 307 and unplug the power cord.
2. Connect your theater processor Main Left and Right interconnects into the MD
307 Hybrid Integrated Amplifier through the A3 input.
3. Connect your Main Left and Right speakers to the MD 307 Hybrid Integrated
Amplifier speaker connections.
4. Re-connect the power to the MD 307 Hybrid Integrated Amplifier. Push the
“POWER” button to the “ON” position.
5. Push the input button or use the remote to select input Aux 3. On the remote
Select input and 00. You will see the display switch to P1 and then the volume
display will go dark, indicating that there is no volume being controlled by the MD
307.
6. Input P1 is now the dedicated input and the volume is controlled by your home
theater processor. To go back to normal operation push the input 00 button on
the remote.
HOOKING UP A SUBWOOFER TO YOUR SYSTEM
1. Unplug the power cord to the MD 307 Hybrid Integrated Amplifier.
2. Using RCA cables, connect one end to the
Pre Out output marked on the rear of
the MD 307, the other end to your subwoofer.
3. Turn the subwoofer “ON”.
4. Re-connect the power to the MD 307 Hybrid Integrated Amplifier. Push the
“POWER” button to the “ON” position and adjust the volume level to suit you.
Please note the volume of the subwoofer is controlled by the volume control on the
Hybrid Integrated Amplifier.