Magnum Dynalab MD-208 - Manual (Page 9)

- 9 -
RC8 REMOTE CONTROL
Unpacking the Remote:
• Remove the remote from its plastic bag, and install the 3 AA batteries provided
• Test the remote to make sure that all functions are operating correctly.
FUNCTIONS OF THE RC8 REMOTE
1. POWER MAIN: Power ON & OFF
2. TUNER REMOTE ON/OFF: This will power up the IR remote stage of the analog
tuner section. If this is ON, the tuner can only be adjusted using the remote, and
not manually. Similarly, if this feature is OFF, the tuner can only be adjusted
manually (using the tuning dial on the faceplate), and not with the remote.
3. TUNE UP/TUNE DOWN: Changes the FM frequency when using the FM tuner as
a source. Hold either the “TUNE UP” or “TUNE DOWN” button until you reach the
desired station. The longer you hold the button the faster the frequency changes.
To FINE TUNE hold either button for a shorter time until your center tune meter
is centered.
4. PRESETS: Your Precision remote gives you the ability to store and scan up to 20
preset stations. To program a preset station, first tune to the desired station
and then push “STORE”. Then select the preset memory position you want to
store this station in by selecting two digits. For Presets 1-9 you must select 01-
09 and for 10+ directly enter the number. To recall these presets you must
push “PRESET” and then enter the two-digit preset you wish to recall.
5. PRESET UP/PRESET DOWN: Scans up and down the FM frequency range
according to the presets you have programmed into the FM tuner.
6. BALANCE LEFT/BALANCE RIGHT: Increases the relative output of the selected
speaker (left/right) compared to the other speaker.
7. VOLUME UP/VOLUME DOWN: Increase or reduces the volume level of the
preamplifier section of the MD 208.
8. INPUT: Adjusts the selected source received by the preamplifier section of the
receiver (i.e. Tuner, CD, Aux 1).
9. AUDIO MUTE: Mutes the amplifier section of the receiver.