NextoDI ND2730 - Manual (Page 9)

11
ND2730 INTERFACE
2. Key operation
The ND2730 is operated by a single control key which can be used in five different
ways. The display shows you the “ ” (Short) or “ ” (Long) symbol as a means
to invoke the desired function.
Symbols Operation
(Short)
(Long)
Press once and release immediately
Press and hold the key for more than two seconds.
Push the key in the appropriate direction.
Up/down movements are supported.
▲▼
3. The LCD Display
Remaining capacity of the internal hard disk drive.
① If the capacity of the internal hard disk drive is uncertain, the display will be
grayed out. A capacity check will be performed automatically during power on
or power off.
② Remaining capacity of the rechargeable battery
The battery capacity is displayed four ways: (32 1empty) by the battery
gauge.
Full: 80% ~ 100%
1 st Gauge: 5% ~ 30%
Empty: Under 5%
2 nd Gauge: 30% ~ 80%
① ②
③
④
XCopy Ready
245.0 G
Menu Off
③ Current status of the device.
④ Available functions for the current screen. The display varies depending on
the function in use.
FORMATTING THE HARD DISK DRIVE
12
10. Formatting the Hard Disk Drive
The hard disk drive in the ND2730 should be formatted with the "FAT32" file
system. Only one (the first) partition can be used.
Do not attempt to format the ND2730 disk drive with a computer. Use only the
format function on the ND2730. This will allow the hard disk to be read by either
the Windows or Mac operating systems.
Caution
● The ND2730 can work only with one partition in the file format
"FAT32". Therefore, the ND2730 formats the hard drive in the
"FAT32 file system."
To Format a New Hard Disk
The ND2730 must not be connected to a computer via USB or FireWire 800
(IEEE 1394b). Remove any memory card or USB device.
OK Back
245.0 G
HDD Format
All data in HDD
will be deleted
Format HDD?
245.0 G
Preview
Self Test
Auto Copy On
Buzzer: On
Format
Sel Back
To re-partition/format the hard disk drive, press the
control key once at the [XCopy Ready] mode to get to
the menu ("S-Menu"). Move the highlighted cursor to the
[Format] menu option with the control key.
Press the control key once to select [Format].
Confirm the selection by pushing the control key upward.
You can cancel the operation by pressing and holding the
control key or power key.
Reference
● With Windows XP, hard drives are formatted only with the file system “NTFS”—the
FAT32 option is no longer available. For MAC OS, hard drives are formatted with the
file system HFS+. NTFS and HFS+ are incompatible with the ND2730.