Night Optics Krystal 950L Generation 2+ B/W Clip-on Sight - Manual (Page 9)

8 NIGHT VISION
Visual
Perform the following test in a daylight of bright
room light (not fluorescent light).
Place the lens cap on the objective lens. Turn
device on and observe that they shut off within
70 (+30) seconds after energized.
Turn device OFF and then ON to reenergize.
No visible image
a) Objective lens cap has not been removed.
b) Battery cap is loose
c) Incorrect Battery installation
d) Weak battery
a) Remove cap
b) Tighten cap
c) Re-insert battery correctly
d) Replace battery
Image flickers, flashes,
or clicking is heard
Normal for new battery to cause this for first
five minutes.
If condition continues contact
manufacturer for service
instructions.
Image dimmer
than usual
a) Weak batteries Replace the batteries
Device fails to
activate a) Visual.
b) Check for defective, missing or
improperly installed batteries.
a) Turn switch to OFF position and
turn ON.
b) Replace battery or install correctly.
Poor image quality
a) Check objective lens or eyepiece focus.
b) Check for fogging or dirt on lens.
a) Refocus.
b) If image quality is still poor, contact
manufacturer for assistance.
Diopter adjustment
cannot be made
a) Check to see if Diopter Ring Fastener is
tightended.
b) Check to see if the Diopter Ring is bent or
broken.
a) Loosen Diopter Ring Fastener.
b) If damaged, contact manufacturer
for assistance.
Battery
compartment
difficult to open
a) Visually inspect for the presence of an o-ring.
b) Check for damaged battery cap.
a) If o-ring is missing, contact
manufacturer for assistance.
b) If damaged, return to
manufacturer.
Device does not shut
OFF
Visual
a) Remove Batteries.
b) Return device to manufacturer.
Device does not shut
OFF when exposed
to high-light If damaged, return to
manufacturer.
MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION
TROUBLESHOOTING PROCEDURES