Outdoor Great Room Crystal Fire - Manual (Page 16)

Page | 16 www.outdoorrooms.com Crystal Fire 42435 REV J 5.24.12
Inspect Maintenance Tasks
Burner Assembly
1 Remove decorative glass and examine burner. Vacuum and wipe
out as needed. Use caution when cleaning these areas
2 Inspect for warping and corrosion. Repair as necessary
3 Check the hose connecting the LP gas cylinder to ensure it is not
damaged. Replace as necessary.
4 Verify air shutter area is clean
Burner Ignition and Operation 1 Verify all gas connections are tight and leak-free
2 Clean burner top, inspect for plugged ports, corrosion, or
deterioration. Replace burner if necessary.
3 Inspect for flame problems.
4 Verify air shutter is clear of dust and debris and is in correct
position for the gas type being used.
5 Inspect orifice for soot, dirt, or corrosion
6 Verify manifold and inlet pressures. Adjust regulator as required.
Gas Hose with Regulator 1 The gas hose with regulator supplied with appliance must be used
for LP installations. The replacement bust be those specified by the
appliance manufacturer
9
Service and maintenance
Although the frequency of appliance servicing and maintenance will
depend on use and the type of installation, a qualified service
technician should perform an appliance check-up annual.
Storage of an appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance.
The use of a vinyl table cover is highly recommended to keep your
table and burner looking new and ensuring extended trouble-free
operation.
Maintenance and Service Tasks
For service calls: Contact the dealer your product was purchased from first.
Contact the Outdoor GreatRoom Company at 1-866-303-4028 if further assistance is needed.