Outdoor Great Room San Juan Fire Pit - Manual (Page 6)

6 | P a g e
Igniter Installation
Your burner includes one of two styles of igniter box. These can be
distinguished by the number of wire connector prongs on the back side. If
one prong is present, proceed to instructions for “Style A” . If two prongs
exist, proceed to “Style B” . Note: Before installing ignition system, ensure
that gas valves are closed and gas is disconnected for safety.
Style A (One prong, self-grounding)
To properly install this igniter style,
see diagram above. Self-grounding
igniters are designed to be installed
mounted to a metal surface such as
an Outdoor GreatRoom Company
control panel.
Once properly grounded, located
the black wire hanging from your
burner and insert it into the port on
the back side of the igniter.
Style B (two prongs, externally grounded)
This igniter relies on external grounding for proper
operation.. See above diagram for mounting sparker
box correctly.
To install igniter wire, locate the black wire hanging
from burner and plug it into either port on backside of
igniter box.
To install grounding wire, locate a nearby nut and bolt
on bottom of burner and loosen the nut enough to
slide the forked end of the included grounding wire
underneath the nut as shown above and retighten nut.
(Some burner models may arrive with grounding wire
already attached)
Plug the free end of grounding wire into the back of
the igniter box to complete installation.
Burner should be installed in
top before installing igniter
wire and grounding wire (if
applicable). Sparker box itself
may be easier to install before
top is in place.