Maintenance – Outdoor Great Room Santa Fe 36 User Manual

Page 7

Advertising
background image

FOR YOUR SAFTY READ BEFORE LIGHTING

A. Before operating smell all around the appliance area for gas odors and next to the floor because some gas es

are heavier then air and will settle on the floor.

B. Use only your hand to turn the manual gas control valve. Never use tools. If the valve will not turn by hand, do

not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or
explosion,

C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to

inspect the appliance and replace any part of the control system and any gas control which has been under
water.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier’ from a neighbors phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

LIGHTING INSTRUCTIONS

1.

Remove protective storage cover and locate the manual gas control valve and igniter button on the fire pit.

2.

Make sure fuel supply is properly connected and turned on at the source / tank.

3.

Depress igniter button until you hear it sparking. You will hear a small popping noise. Keep igniter button
pushed in while turning the fuel flow valve to the full flow position at the fire pit. The fire pit should light within
5 seconds. If you do not hear the igniter sparking you may need to replace the battery. Replace with a
standard AAA battery, directly behind the rubber push button knob, (unscrew knob to access battery).

4.

If a flame does not start within 10 seconds, shut off all gas supply and wait FIVE, (5), minutes to allow all gas
fumes to clear. Re-try or go to trouble-shooting and start from Step-1 again.

TO TURN OFF GAS

Turn the ON/OFF valve to the off position at the unit for Natural Gas unit. For LP unit, turn the ON/OFF valve to the OFF
position at the unit and then turn the valve on the LP tank to the OFF position clockwise.

NOTE

The

propane regulator in this appliance is equipped with a low flow protection device. Unless the propane cylinder valve is

opened before the TRIPARO valve, the gas flow will be reduced resulting in a very small flame.
To reset this device, shut off the TRIPARO valve, then the propane cylinder valve.
Follow the lighting procedure ensuring the propane cylinder valve is opened before the unit is.

MAINTENANCE

1. The appliance should be inspected before initial use and inspected and cleaned at least annually by a qualified service
person.
2. Tampering is DANGEROUS and voids all warranties. Any component that is found to be faulty, must be replaced with
an approved component.

Advertising