PDR Mounts swm050 - Manual

M odel
Thank you for purchasing the PDR product
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel
display and the mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
Model SWM-050 FEATURES
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the
mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and
airflow.
1
Mounts by
A division of David Engineering & Mfg. Inc.
SWING WALL MOUNT SWM-050
All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
Check the PDR website for details @
www.PDRmounts.com. We are not liable for improper installation that results in damage
to mounts, adapters or presentation equipment.
s Designed for a wide variety of displays
s 75mm and 100mm
VESA mounting pattern
s Fingertip tilt-swivel adjustment
s Tilts 5 deg up and 15 deg down
s Rotates left and right
s Integrated cable management design
s 50 lb load rating
s Made and serviced in the USA