PDR Mounts pdm625t-8 - Manual

M odel
Thank you for purchasing the PDR panel display wall mount.
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
Features
1
All PDR mounts and adapters carry a limited lifetime warranty against defects in material and workmanship.
We are not liable for improper installation that results in damage to mounts, adapters or presentation equipment.
Mounts by
A division of David Engineering & Mfg. Inc.
PDM 625T-8 PANEL DISPLAY MOUNT
Low profile 2 5/8”
16”, 24” or 32” stud mounting
Easy installation
Flat to 13 deg tilt
Lateral movement from center for better viewing position
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the
weight of both the display and the mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
Special techniques are necessary for installation of the panel display mount.
? Do not attempt to perform this work by yourself.
?
Request an installation specialist to install this unit.
?
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
? Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting
unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow.