PDR Mounts MDWM150 - Manual

Model
MDWM150 MONITOR DISPLAY WALL MOUNT
To ensure the correct usage, please read and follow the instruction manual thoroughly. Please store the instructions in a safe place for future reference.
3. MOUNT THE MONITOR ASSEMBLY TO THE WALL
Fig 6
1 4
Special techniques are necessary for installation of the panel display mount.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Projector wall mounting application fig 2
All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
Check the PDR website for details @
www.PDRmounts.com We are not liable for improper installation that results in
damage to mounts, adapters or presentation equipment.
Mounts by
A division of David Engineering & Mfg. Inc.
!Suitable for displays with 75mm & 100mm
vesa hole pattern
! Simple to adjust no tools required
!Quick monitor removal with exclusive
“Bayonet slide system”
Features
Thank you for purchasing the PDR monitor mount .
Place the monitor assembly into the bayonet slots on the mounting plate ( small end into large end) engages fig 6.
slide the unit upwards and out.
To remove,
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to
withstand the weight of both the monitor and the mount.
Fully tighten all of the mounting screws as specified in the instructions.
Mounting hardware
Wall anchors 4 pcs
Monitor mounting screw 4 pcs
Bayonet plate
Rev 062105