PDR Mounts UCMM50 - Manual (Page 4)

3. MOUNT THE MONITOR ASSEMBLY TO THE CABINET
Fig 6
4
Place the monitor assembly into the bayonet slots on the mount ( small end into large end) and slide forward until the safety
lever engages fig 6. Adjust the tri knobs for monitor height and angle for best viewing. To remove, lift the quick disconnect lever
and slide the unit backwards and out.
NOTE: To store . Rotate the monitor parallel to the front, Loosen the side knob fold up and tighten the tilt knob. Larger monitors or
shallow cabinet will not allow monitors to fully retract.
Quick Disconnect Lever
Plastic knob
height adjust
VIEW
Tilt adjust
STORE