Petsafe Drinkwell® Original Pet Fountain - Manual (Page 5)

www.petfountain.com
REASSEMBLY OF YOUR FOUNTAIN AFTER CLEANING
Turn the bowl over. Reattach the motor by pushing the threads of the motor
through its hole in the bowl. The motor goes in at a right angle to the bowl,
(as it was when you pulled it out toward you to remove it, Fig. 4B). In order
for the motor to screw or turn into place, the threads must be pushed past the
threads of the bowl. If you cannot turn the motor into its resting position, it is
not pushed into the hole as far as it will go.
Turn the motor into its resting position by pushing the end that is jutting out
towards the bowl. The motor should now be even with the bottom of the bowl.
Place the stator over the neck of
the motor (Fig. 6). Make certain it is
straight, (in the 12 o’clock position).
Join the flow control knob and stator
together by placing the tabs of the
knob into the groove of the stator,
(Fig. 7).
Fig. 6
Fig. 7
Fig. 8
Fig. 9
STATOR
TABS GROOVE
CHECK THE POWER CORD FOR ANY DAMAGE
BEFORE PLUGGING IN THE FOUNTAIN.
HOLD THESE PARTS IN PLACE with one hand
while attaching the housing with the other hand,
(Fig. 8). Attach the housing by just sliding the cutout
in the wall of the housing down IN BETWEEN the
control knob and the stator, (Fig 9).
The housing will click into place when the tabs on
its sides enter the slots in the bowl. There is an
alignment peg in the bowl for stability which will
automatically be joined with the corresponding
hollow tube under the housing.
5
1.
2.
3.
4.
5.
6.