Creative Labs Creative Handsfree with Bluetooth Technology CB2455 - Manual (Page 3)

3
Using Your Headset
*Some features are available only for certain mobile phones. Refer to your mobile phone’s documentation.
Usage Action
Turning on
headset Press and hold the Multi-function button for three seconds. The LED turns
blue.
Turning off
headset
Press and hold the Multi-function button until the LED turns red.
Making a call
Make sure that your headset is turned on (it may be in standby mode when
inactive), dial the number, and then proceed with your call.
Answering a call
If there is an incoming call, your earpiece and mobile phone rings, and your
headset beeps. Press the Multi-function button.
Ending a call
Press the Multi-function button to end a call. You can also end a call using
your mobile phone.
Using Voice Dial*
Press the Multi-function button and when you hear a beep, say the voice
tag.
Using Last
Number Redial*
Press the Multi-function button twice within one second.
Adjusting volume
Press the Volume Increase or Volume Decrease button to gradually
increase or decrease the volume.
Rejecting a call Press and hold the Multi-function button for three seconds.
Putting a call on
hold Press and hold the Volume Increase and Volume Decrease buttons
simultaneously, for one second.
Switching between
calls Press the Volume Increase and Volume Decrease buttons
simultaneously.
Muting or
unmuting the
microphone Press and hold one of the Volume buttons until the LED alternately blinks
red and blue.
To unmute the microphone, press one of the Volume buttons.
Clearing all
headset pairings
Make sure that your headset is turned off. Press and hold both Volume
buttons simultaneously for 20 seconds. The LED alternately blinks red and
blue. Press and hold both Volume buttons for two seconds. You hear two
beeps and your headset turns itself off automatically. Charge your headset for
a few seconds to reset your headset. All current pairings are cleared.
En_CB2455.book Page 3 Wednesday, June 8, 2005 9:32 AM