Ryobi EMM0001 - Manual (Page 12)

12 13
USING THE LIGHTING ATTACHMENT
See Figure 14.
The lighting attachment uses three medium-intensity LED
lights to provide extra illumination in dark workspaces. The
light beam can be adjusted up to 90˚, and the lighting at-
tachment can be rotated 360˚. Turn the lights on and off by
depressing the on/off button located on top of the attach-
ment.
USING THE MAGNETIC TRAY ATTACHMENT
See Figure 15.
Position the tray in a horizontal or vertical position and tighten
the locking knob to secure in place. The magnetic surface
will hold small tools and/or nuts, bolts, screws, etc. The
small holes on the tray can be used to hold screwdrivers or
other cylindrical tools.
USING THE HELPING HAND ATTACHMENT
See Figure 16.
The helping hand attachment will support a workpiece of up
to 5 lbs on smooth surfaces. The angle of the helping hand
can be adjusted up to 35˚ and is secured in place using the
locking knob. The length of the arm can be adjusted up to
1-1/2 in. by loosening the center screw, sliding the arm up
or down as desired, then retightening the center screw to
secure.
WARNING:
Do not use the helping hand to support anything weigh-
ing more than 5 lbs. Failure to heed this warning could
cause serious personal injury.
OPERATION
Fig. 15
Fig. 16
Fig. 14
LIGHTING
ATTACHMENT
IN VACUUM BASE
MAGNETIC TRAY
ATTACHMENT
HELPING HAND
ATTACHMENT
LOCKING KNOB
LOCKING
KNOB
LOCKING
KNOB