Ryobi P900 - Manual

TOOLBOX FRAME
TOOLBOX
FRAME
The Ryobi toolbox is a great way to keep your hand tools organized, accessible, neatly stored, and ready to transport. Its
large storage capacity accommodates a wide variety of tools and accessories.
Adjustable dividers inside the toolbox allow you to customize the storage compartments to fit your specific requirements.
Dividers can be raised and fastened into place whenever needed, then unfastened and lowered when a larger storage area
is desired.
A zippered cover helps protect your tools from dust, debris, and moisture. When not needed, the cover can be rolled back-
ward and stored in the pocket located on the back side of the toolbox.
Before using the toolbox for the first time, some minor assembly is required.
MEDIUM TOOLBOX
P900
n Lower the fabric body over the toolbox frame.
Fig. 1
n Insert the toolbox handle through the vertical opening
located on the end panel of the toolbox frame.
Fig. 2
Fig. 3
END
PANEL
END PANEL
FABRIC
BODY
HANDLE
ASSEMBLING THE TOOLBOX:
See Figures 1 - 8.
n
Raise the toolbox frame’s end panels until they are stand-
ing upright.
SLEEVES
n Thread handle through the sleeves in the center divider
section and seat in the vertical opening on the opposite
side of the frame.
Fig. 4
n Secure the handle to the toolbox frame using the end
caps provided. While holding the handle firmly, seat end
cap on handle end and apply pressure until it snaps into
place. Repeat with other end cap.
Fig. 5
END
CAP
n Pull the shoulder strap loops through the openings in the
fabric body.
LOOP(S)