Ryobi RT102 - Manual (Page 12)

1
1 rev=1/8”
aSSeMBLY
attaCHING tHe rOUter GUarD tO tHe
rOUter
See Figure 9.

Place the router guard on the back of the router.
 Align the slots in the guard with the holes in the router.
 Secure the router guard to the router with the two guard
screws.
attaCHING tHe rOUter tO tHe taBLe
See Figure 10.
Attach the router to the router table after you have assembled
the table and installed the router guard.

Place the router table right side up with the front edge
closest to you.
 Be sure the table is stable and rests on all four legs.
 Hold the router upside down so that the back of the router
faces you.
 Align the holes in the center of the table with the holes in
the router.
NOte: To attach router, use the two right holes and the
back left hole.
 Hold the router with one hand and securely tighten each
of the flat head screws
with the other hand.
MOUNtING tHe taBLe tO a WOrK
taBLe
See Figures 11 - 12.

Place the router table right side up on a sturdy work
surface; e.g., work stand, workbench, counter top.
 Mark the holes with a pencil.
 Remove the router table.
 Drill four holes through the work surface.
 Place the router table back on the work surface, align-
ing the holes in the table legs with the holes in the work
surface.
NOte: Position the router table surface at approximately
hip height.
 Insert four bolts (not included, 1/4-0 recommended) and
tighten securely with flat washers, lock washers, and hex
nuts (not included).
NOte: If you plan to transport the router table to different
locations, we recommend that you attach it permanently
to a mounting board that you can easily clamp to a work
table.
Fig. 9
Fig. 11
Fig. 1
Fig. 10
BoLTS
HEX NUT
WoRK TABLE
FLAT
WASHER
CLAMPS
MoUNTING
BoARD
WoRK TABLE
FRoNT EDGE
HoLES
FLAT HEAD
SCREW
GUARD
SCREWS
RoUTER
GUARD
LoCK WASHER