Ryobi A113TS1 - Manual

OPERATOR’S MANUAL
MANUEL D’UTILISATION
MANUAL DEL OPERADOR
WARNING:
To reduce the risk of injury, do not attempt to use this product
until you have read thoroughly and understand completely this
operator's manual and the operator's manual for the WS720
or WS721 Tile Saw.
For use only with the RYOBI WS720 or WS721 tile saw.
SAVE THESE INSTRUCTIONS
UNPACKING
This product requires assembly.
n
Carefully remove the product from the box. Make sure that all
items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Loose Parts List are
already assembled to your product when you unpack it. Parts on
this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may
have been improperly assembled could result in serious
personal injury.
n Inspect the product carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
n If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this tool
until the parts are replaced. Use of this product with damaged
or missing parts could result in serious personal injury.
LOOSE PARTS LIST
See Figure 1.
TOOLS NEEDED
See Figure 2.
Adjustable Wrench or 13 mm Wrench
ASSEMBLING THE STAND
See Figures 3 - 5.
The support brackets and stand legs have corresponding letters
for easy assembly.
n
Insert stand legs, labeled “A”, into end tubes of the support
bracket labeled “A”. Angled ends of stand legs should face away
from each other so they resemble a “V”. Align holes for hardware.
Repeat with second support bracket and legs labeled “B”.
n Fit leg assemblies into braces. Leg assembly “B” rests on inside
of braces. Leg assembly “A” rests on the outer side. Line up
holes in the braces and legs. Install hardware through holes.
n Using wrench, tighten hardware.
n Place stand on level ground and line up grooves under tile saw
table with brackets on stand. Position table onto stand.
n Be sure the tile saw is on level ground and the stand is sturdy
before use.
CALIFORNIA PROPOSITION 65
WARNING:
This product may contain chemicals, including lead, known to
the State of California to cause cancer, birth defects or other
reproductive harm. Wash hands after handling.
WARRANTY
RYOBI
®
POWER TOOL - LIMITED THREE YEAR WARRANTY AND
90 DAY EXCHANGE POLICY
One World Technologies, Inc., warrants its RYOBI
®
power tools with
the following conditions:
90-DAY EXCHANGE POLICY: During the first 90 days after date of
purchase, you may either request service under this warranty or you
may exchange any RYOBI
®
power tool which does not work properly
due to defective workmanship or materials by returning the power tool
to the dealer from which it was purchased. To receive a replacement
power tool or requested warranty service, you must present proof of
purchase and return all original equipment packaged with the original
product. The replacement power tool will be covered by the limited
warranty for the balance of the two year period from the date of the
original purchase.
WHAT THIS WARRANTY COVERS: This warranty covers all defects
in workmanship or materials in your RYOBI
®
power tool for a period of
three years from the date of purchase. With the exception of batteries,
power tool accessories are warranted for ninety (90) days. Batteries
are warranted for three years.
HOW TO GET SERVICE: Just return the power tool, properly packaged
and postage prepaid, to an Authorized Service Center. You can obtain
the location of the Service Center nearest you by contacting a service
representative at One World Technologies, Inc., P.O. Box 1207, Anderson,
SC 29622-1207, by calling 1-800-525-2579 or by logging on to
www.ryobitools.com. When you request warranty service, you must
also present proof of purchase documentation, which includes the
date of purchase (for example, a bill of sale). We will repair any faulty
workmanship, and either repair or replace any defective part, at our
option. We will do so without any charge to you. We will complete the
work in a reasonable time, but, in any case, within ninety (90) days
or less.
WHAT’S NOT COVERED: This warranty applies only to the original
purchaser at retail and may not be transferred. This warranty only covers
defects arising under normal usage and does not cover any malfunction,
failure or defects resulting from misuse, abuse, neglect, alteration,
modification or repairs by other than Authorized Service Centers.
One World Technologies, Inc. makes no warranties, representations
or promises as to the quality or performance of its power tools other
than those specifically stated in this warranty.
ADDITIONAL LIMITATIONS: Any implied warranties granted under
state law, including warranties of merchantability or fitness for a
particular purpose, are limited to three years from the date of purchase.
One World Technologies, Inc. is not responsible for direct, indirect, or
incidental damages, so the above limitations and exclusions may not
apply to you. This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
TILE SAW STAND
STAND POUR SCIE À CARREAUX
PEDESTAL PARA SIERRA DE LOSAS
A113TS1
ENGLISH