Ryobi RY09605 - Manual

RYOBI ART WORK
Art Part No. : 987000898 Rev. 01
Where Used : 987000898
Refer to Drawings for Dimensions.
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
1
ENGINE STARTING PROCEDURE
987000898
10-29-09 (REV:01)
Note: When starting the blower for the first time or
when the battery voltage is low, it may be necessary to
manually start the blower.
PRESS
START/STOP switch to START position.
PRESS and HOLD START/STOP switch in STOP position
until engine stops
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
CALL
1-800-860-4050
www.ry
obitool
s.com
®
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
PRIME
press the PRIMER BULB 7 times.
DO NOT engage the THROTTLE until engine starts and runs.
SET
START lever to " START " position.
1 GALLON
GAS
2
3
4
5
6
Push the throttle to run.
x7
2.6
oz.
1
2
3
5
6
7
7
Place battery pack in the blower. The battery pack for this tool
has been shipped in a low charge condition to prevent possible problems.
Therefore, you should charge overnight prior to use.
4
WARNING: This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.