Clarion AB243R AB243RG - Manual (Page 5)

AB243R/AB243RG
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
Turning on the power and adjusting
the volume
1) Press the POWER button 5.
* To turn the power on and off, press the POWER
button.
2) Turning the Rotary knob 3 clockwise
increases the volume; turning it counterclock-
wise decreases the volume.
* The volume level is from 0 (minimum) to 33 (max-
imum).
Setting the Z-enhancer
This unit comes with 3 types of sound tone
effects stored in memory. Select the one you
prefer.
* The factory default setting is “OFF”.
Each time you press Z-EHCR button 7 , the tone
effect changes in the following order:
“Z-EHCR 1”
➜ “Z-EHCR 2” ➜ “Z-EHCR 3” ➜
“OFF”
➜ “Z-EHCR 1”...
• Z-EHCR 1 : bass emphasized
• Z-EHCR 2 : treble emphasized
• Z-EHCR 3 : bass and treble emphasized
• OFF : no sound effect
Adjusting the tone
Press A-M button 4 and select the item to
adjust. Each time you press A-M button 4, the
item changes in the following order:
“BASS 0”
➜ “TREB 0” ➜ “BAL 0” ➜ “FAD 0”
➜ Function mode...
Adjusting the bass
1. Press A-M button 4 and select “BASS”.
2. Turning the Rotary knob 3 clockwise
emphasizes the bass; turning it counterclock-
wise attenuates the bass.
* The factory default setting is “0”. (Adjustment
range: –6 to +6)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Adjusting the treble
1. Press A-M button 4 and select “TREB”.
2. Turning the Rotary knob 3 clockwise
emphasizes the treble; turning it counter-
clockwise attenuates the treble.
* The factory default setting is “0”. (Adjustment
range: –6 to +6)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Adjusting the balance
1. Press A-M button 4 and select “BAL”.
2. Turning the Rotary knob 3 clockwise
emphasizes the sound from the right speak-
er; turning it counterclockwise emphasizes
the sound from the left speaker.
* The factory default setting is “0”. (Adjustment
range: L9 to R9)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
Adjusting the fader
1. Press A-M button 4 and select “FAD”.
2. Turning the Rotary knob 3 clockwise
emphasizes the sound from the front speak-
ers; turning it counterclockwise emphasizes
the sound from the rear speakers.
* The factory default setting is “0”. (Adjustment
range: F9 to R9)
3. When the adjustment is complete, press A-M
button 4 several times until the function
mode is reached.
6
English
5. OPERATION
Basic Operations
Note: Be sure to read this chapter by referring to the front diagrams
in chapter 2. CONTROLS on page 3 (unfold).
CAUTION