Waterworks Easton Vintage Low Profile Three Hole Wall Mounted Lavatory Faucet with Porcelain Lever Handles - Manual

These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON WALL MOUNTED LAVATORY FAUCET WITH CROSS HANDLES
(EALS61 & GUSV27R) & LEVER HANDLES (EALS62, 63, 64, 65 & GUSV25R) All
dimensions are based on original specification and are subject to change and variation. Please consult
your Design Associate for current specifications.
Installation Guidelines
W A T E R W O R K S ®
4/06
Easton Wall Mounted Lavatory Faucet
EALS61 (Cross Handles) & GUSV27R (Rough)
IMPORTANT
To ensure this product is installed properly,
you must read and follow these guidelines.
The owner/user of the faucet must keep
this information for future reference.
This faucet must be on-site prior to rough in and
allows the installer to visualize the installation and
match the 8" center spread.
Be sure your installation conforms to local codes.
Refer to the specification and assembly drawings
attached. Faucet is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
Check countertop and sink measurements to assure
the spout projects far enough into the sink.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
Do NOT use putty during this installation.
ROUGH-IN
Rough in Depth: 3" from center of inlets to surface
of the finished wall.
Rough in Height: 3 ¾" minimum from center of
cartridge stem to surface of counter top to allow
for lever handle clearance in the open position.
1. Run ½" hot and cold supply lines. The spread
between supplies is 8" on center and is NOT
adjustable.
2. Install a well supported 1/2" sweat x 1/2" female IPS
adapter onto each supply line.
3. Verify the supplies are secure, level, at the proper
spread of 8" and equal depths.
4. Remove the nuts (6) from the faucet body inlets
then pull out the inlet adapters (6a,6b).
5. Slide the nut over the inlet adapter and thread them
into the supplies. Use a 10 mm hex wrench to
tighten the adapters.
6. Align the faucet body onto the supplies making sure
that the o-ring (6b) does not get pinched then
tighten the nuts (6) to secure the faucet.
7. Verify the supplies and faucet body are secure then
turn on the supplies and check for leaks.
EALS62 (Metal Lever Handles) & GUSV25R (Rough)
EALS63 (White Porcelain Lever Handles) & GUSV25R (Rough)
EALS64 (Black Porcelain Lever Handles) & GUSV25R (Rough)
EALS65 (Oak Lever Handles) & GUSV25R (Rough)
3"
1 1
4
"
3 1
2
"
6 1
2
"
2 3
8
"
2 1
8
"
2 3
8
"
3 1
2
"
3"
1 1
4
"
6 1
2
"
2 3
8
"
2 3
8
"
2 1
8
"
3"
3 1
2
"
3"
3 1
2
"
EALS62 EALS63, 64, 65
2 3
8
" 2 3
8
"
3 3
8
"