Waterworks Etoile Gooseneck Three Hole Deck Mounted Lavatory Faucet with Metal Cross Handles - Manual

2 3 ⁄
8
"
3 5 ⁄
8
"
1 1 ⁄
4
"
4 5 ⁄
8
"
6"
2 3 ⁄
8
"
8"-12"
Note:
Drilling hole size: 1
1 ⁄ 4 "
3 3 ⁄
8
"
1 1 ⁄ 4 " Flanged tail
piece included
Etoile Lavator y Faucet
Installation Guidelines
ETLS 42 INSTALLATION GUIDELINES
Use only a protected, smooth-jawed, or strap wrench on any finished surface.
If possible, install this faucet assembly on the lavatory before setting.
To remove the trim from the valve body, unscrew the index assembly,
exposing screw for handle.The cover and escutcheon should be hand tight.
DO NOT use putty on deck fittings. Upper and lower washers are provided.
When you screw the escutcheon onto the deck valve body, expose several
threads above it. Next, screw down the valve cover until it seats.Then move
up the escutcheon until it loosely meets the bottom of the cover.
Finally, tighten the bottom lock nut to secure the valve to the deck.
Once the spout is securely mounted, install the flexible hoses between the
spout and valve bodies using the gaskets provided.
The upper waste assembly can be set with putty.
Check for leaks.
Adjust the vertical pop-up rod so that the knob rests 1 ⁄ 32 " above the spout
when the waste is in the full open position. If rod hits the trap, cut excess.
Basin nuts are provided.
After installation, unscrew and remove the aerator assembly. Carefully open
the hot and cold valves fully to flush out any debris in the supply
lines. Once the lines have been flushed, close the valves and reinstall the
aerator assembly.
If further assistance is required, please contact Product Support at
1-800-927-2120 (8am–7pm EST).
3/06
These guidelines have been prepared for the professional contractor to aid in the installation of:
ETOILE LAVATORY FAUCET (ETLS 61)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
ETLS61