Waterworks Formwork Low Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Three Hole Deck Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 1 of 3 4.16.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK DECK MOUNTED LAVATORY FAUCET WITH METAL KNOB HANDLES (STYLE#
FMLS01) & METAL LEVER HANDLES (STYLE# FMLS10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Style No. FMLS01
with Metal Knob Handles
Style No.
FMLS10
with Metal Lever Handles
SPECIFICATIONS:
Drain Depth: 1-1/2" MIN - 1-3/4" MAX
Drain Hole Diameter: Ø 1-3/4"
Drain Style: Push Touch (Drain Included)
Fitting Hole Diameter: 1-3/8"
Handle Spread: 8" MIN - 12" MAX
Inlet Connection Size: 1/2"
Inlet Connection Type: Male with Supply Nut
Maximum Deck Thickness: 1/2" MIN - 2" MAX
Water Pressure: 20 psi MIN - 80 psi MAX
Recommended Water Pressure: 45 psi
Restricted Maximum Flow Rate: 2.2 gpm
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain plumber's putty may stain stone
or tile surfaces.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-3.
1. Remove the NUT, METAL WASHER, RUBBER
WASHER & PLASTIC SPACER from the bottom of
the SPOUT SHANK.
2. Insert the SPOUT and SPOUT SHANK through the
hole on the mounting surface making sure the
RUBBER GASKET is underneath the spout.
3. Re-install the PLASTIC SPACER, RUBBER WASHER,
METAL WASHER & NUT (in that order). Tighten the
NUT to secure the spout.
METAL WASHER
NUT
RUBBER WASHER
PLASTIC SPACER
RUBBER
GASKET
SPOUT
SHANK
SPOUT
FLOW RESTRICTING
AERATOR
METAL WASHER
NUT
RUBBER WASHER
PLASTIC SPACER
RUBBER
GASKET
SPOUT
SHANK
SPOUT
FLOW RESTRICTING
AERATOR
FIGURE - 01