Waterworks Formwork Low Profile Three Hole Wall Mounted Lavatory Faucet with Metal Knob Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Low Profile Three Hole Wall Mounted Lavatory Faucet Installation Guidelines
Page 1 of 4
Rev - 01
4.7.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK LOW PROFILE THREE HOLE WALL MOUNTED LAVATORY FAUCET WITH METAL KNOB HANDLES
(STYLE No. FMLS60) & METAL LEVER HANDLES (STYLE No. FMLS70)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. FMLS60
with Metal Knob Handles
STYLE No. FMLS70
with Metal Lever Handles
SPECIFICATIONS:
Control Valve Rough-in Depth Minimum: 2-7/8"
Control Valve Rough-in Depth Maximum: 5-3/4"
Drain Depth Minimum: 1-1/2"
Drain Depth Maximum: 1-3/4"
Drain Hole Diameter: Ø1-3/4"
Drain Style: Push Touch (Drain Included)
Fittings Hole Diameter: Ø1-3/8"
Handle Spread: 8" (NOT ADJUSTABLE)
Inlet Connection Size: 1/2"
Inlet Connection Type: Female NPT
Restricted Maximum Flow Rate: 2.2gpm
Water Pressure Minimum: 20psi
Water Pressure Maximum: 80psi
Water Pressure Recommended: 45psi
REQUIRED PLUMBING DETAILS:
Universal Lavatory Wall Mounted Rough Valve
STYLE No. GULV25 (used with Lever Handle Faucets)
STYLE No. GULV27 (used with Knob Handle Faucets)
IMPORTANT:
¾ To ensure this product is installed properly, you must
read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product must be installed by a professional
licensed contractor.
¾ Be sure your installation conforms to all federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be on-site prior to rough-in. This
allows the installer to visualize the installation and
verify the 8" center spread.
¾ Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
¾ Inspect the product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
TRIM INSTALLATION:
1. Remove the TILE GUARDS and the O-RINGS from the
VALVE as shown in Figure - 01.
FIGURE - 01
FINISHED WALL
VALVE
O-RING
TILE GUARD
FINISHED WALL
VALVE
O-RING
TILE GUARD