Waterworks Julia High Profile Three Hole Deck Mounted Lavatory Faucet with White Porcelain Lever Handles - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 10.06.06
Julia Lavatory Faucet
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA LAVATORY FAUCET WITH CROSS HANDLES (JULS18) & LEVER HANDLES
(JULS20-K, JULS21-K, JULS22-K) All dimensions are based on original specification and are subject to
change and variation. Please consult your Design Associate for current specifications.
3 1
4
"
8"-12"
2 1
2
"Ш
6 3
8
"
5 3
4
"
2 1
2
"
2 1
2
"Ш
3 1
4
"
3 5
8
" 3 1
2
"
2 1
2
"Ш
9 7
8
"
3 1
4
"
JULS20-K JULS21-K, 22-K
2 1
2
"Ø
IMPORTANT
To ensure this product is installed properly, you must
read and follow these guidelines.
The owner/user of the faucet must keep this
information for future reference.
Be sure your installation conforms to local codes.
Refer to the specification and assembly drawings
attached. Faucet is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
If possible, install the faucet assembly on the sink or
mounting surface before setting.
Do NOT use putty during this installation.
SIDE VALVE INSTALLATION
1. Disassemble the index assembly (1-1c) as 1 unit from
the handle by lifting the ring (1) off of the handle.
2. Insert a small bladed screw driver into the handle and
loosen the screw (2) then pull the handle off the
cartridge (5).
3. Unthread the cover (4) from the cartridge (5) then
base escutcheon (6) from the side valve (7). Remove 1
sealing gasket (6b) as an upper seal. Do NOT
remove the other sealing gasket or hardware (7b,7a).
4. Insert the side valve into the hole in the mounting
surface so at least 1" of threads are exposed.
5. Install the upper sealing gasket onto the side valve
then thread the base escutcheon onto the side valve
until it contacts the mounting surface.
6. Thread the cover(4) onto the cartridge hand tight at
which point it will stop.
7. Unthread the base escutcheon until it contacts the
cover which will assure proper side valve height.
8. Tighten the nut (7a) up against the underside of the
mounting surface to secure the side valve.
9. Reinstall the handle and index assembly.
10. Repeat these steps to install the second side valve.
SPOUT AND DRAIN INSTALLATION
11. Loosen the lower tee nut (9a) and upper tee nut
then remove the tee assembly from the spout.
12. Remove the spout mounting hardware (10a,10b).
13. Insert the vertical lift rod (13-13b) into the spout
then insert the spout assembly (10-13b) through the
spout hole of the mounting surface.
14. Secure the spout using the mounting hardware
(10a,10b) then reattach the tee assembly making sure
the washer (9b) is in place.
JULS18 (cross handles)
JULS20-K (metal lever handles)
JULS21-K (white porcelain lever handles)
JULS22-K (black porcelain lever handles-MTO)