Waterworks R.W. Atlas Deck Mounted Marquee Lavatory Faucet with Metal Lever Side Mount Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Marquee Three Hole Deck Mounted Lavatory Faucet
INSTALLATION GUIDELINES
Page 1 of 3 8.7.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS MARQUEE DECK MOUNTED LAVATORY FAUCET WITH METAL SIDE MOUNT LEVER
HANDLES (STYLE# RWLS10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Side Mounted Metal Lever Handles
Style No. RWLS10
SPECIFICATIONS:
Drain Depth Maximum: 2-1/2"
Drain Depth Minimum: 3/8"
Drain Hole Diameter: 1-3/4"
Drain Style: Push Touch (Drain Included)
Fitting Hole Diameter: 1-3/8"
Handle Spread Maximum: 12"
Handle Spread Minimum: 8"
Inlet Connection Size: 1/2"
Inlet Connection Type: Male with supply nut
Maximum Deck Thickness: 1 -5/8"
Minimum Deck Thickness: 1/4"
Maximum Water Pressure: 80psi
Minimum Water Pressure: 20psi
Recommended Water Pressure: 45psi
Restricted Maximum Flow Rate: 2.2gpm
IMPORTANT:
¾ NOTE: The screw on the top of the handle assembly
and on the top of the spout assembly are aesthetic
and does not serve any mechanical purposes and
should not be removed.
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.
SPOUT INSTALLATION:
¾ See Figure 1. for Steps 1-3.
1. Remove the tee, tee rubber washer, nut, metal
washer & spout rubber washer from the bottom of
the spout.
2. Insert the spout into the hole on the mounting
surface making sure the o-ring is underneath the
spout.
3. Re-install spout rubber washer, metal washer and
nut (in that order). Re-attach the tee making sure
the tee rubber washer is in the outlet.
Figure - 01
SPOUT
SPOUT
O-RING
SPOUT RUBBER WASHER
SPOUT METAL WASHER
NUT
TEE RUBBER WASHER
TEE
AERATOR
HANDLE INSTALLATION:
¾ See Figure 2. for Steps 4-8.
4. Remove the rubber washer, plastic washer & nut
from the handle's threaded shank. Note: The inlet
tube may need to be unthreaded and removed in
order to remove nut.
5. Place the handle assembly through the hole in the
deck, along with the outlet hose & inlet tube.
6. Re-install rubber washer, plastic washer and nut
from under the deck. Tighten the nut up against the
bottom of the mounting surface to secure the
handle assembly.