Waterworks .25 One Hole High Profile Kitchen Faucet, Metal Handle and Metal Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
.25
One Hole High Profile Kitchen Faucet with Lever Handle and Spray Installation Guidelines
Page 1 of 3
Rev - 01
10.31.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 ONE HOLE HIGH PROFILE KITCHEN FAUCET WITH METAL LEVER HANDLE AND METAL SPRAY
(STYLE No. PTKM10, PT10KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. PTKM10†
SPECIFICATIONS:
Deck Thickness Maximum: 1-3/8” (35mm)
Fittings Hole Diameter: Ø1-1/2” (38mm)
Handle Turn Angle: Quarter Turn Each Way
Inlet Connection Size: 3/8”
Inlet Connection Type: Compression Connection Adapters†
Integrated Diverter: Yes
Restricted Maximum Flow Rate: 2.2gpm (8.3liters/min)
Spout Reach: 6-5/16” (160mm)
Spout Swivel: Yes
Spray Hose Length: 59” (1.5m)
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
† UK Style No.
PT10KM is supplied with 2 BSP adapters,
assembly required
IMPORTANT:

To ensure this product is installed properly, you must
read and follow these guidelines.
 The owner/user of this product must keep this
information for future reference.
 This product must be installed by a professional
licensed contractor.

Be sure your installation conforms to all federal, state,
and local codes.
 In the State of Massachusetts, all installations must
comply with the rules and regulations set forth within
248 CMR.
 Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.

Inspect the product to ensure you have all the parts
required for proper installation.

Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.

DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
SPOUT INSTALLATION:
1. Remove the HOSES from the EXTENSION TUBES then
remove MOUNTING NUT, METAL WASHER, and
RUBBER WASHER from the SPOUT SHANK. See
FIGURE - 01. Do
NOT remove the RUBBER WASHER
beneath the ESCUTCHEON.
FIGURE – 01
METAL WASHER
HOSE
MOUNTING
HARDWARE
RUBBER WASHER
EXTENSION
TUBE
SHANK
ESCUTCHEON
METAL WASHER
HOSE
MOUNTING
HARDWARE
RUBBER WASHER
EXTENSION
TUBE
SHANK
ESCUTCHEON