Waterworks Julia Two Hole Bridge Articulated Kitchen Faucet, Metal Lever Handles and Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
JULIA
Two Hole Bridge Articulated Kitchen Faucet and Spray Installation Guidelines
Page 1 of 3
Rev - 01
10.30.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA TWO HOLE BRIDGE ARTICULATED KITCHEN FAUCET WITH METAL CROSS HANDLES AND SPRAY
(STYLE No. JUKM42), JULIA TWO HOLE BRIDGE ARTICULATED KITCHEN FAUCET WITH METAL LEVER
HANDLE AND SPRAY (STYLE No. JUKM43).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. JUKM42
Cross
Handles
STYLE No. JUKM43
Lever
Handles
SPECIFICATIONS:
Deck Thickness Maximum: 1-1/2” (38mm)
Fittings Hole Diameter [Spout]: Ø1" (25mm)
Fittings Hole Diameter [Valve, Spray]: 1-1/4” (32mm)
Handle Spread [Spout,
NOT adjustable]: 7-7/8” (200mm)
Handle Turn Angle: Quarter Turn
Inlet Connection Size & Type: 1/2" Male with Supply Nut
Inlet Supply Spread [Spout,
NOT adjustable]: 7-7/8”
(200mm)
Integrated Diverter: N
Restricted Maximum Flow Rate: 2.2gpm (8.3liters/min)
Spout Reach: 18-3/8” (467mm)
Spout Swivel: Yes
Spray Hose Length: 49” (1245mm)
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
IMPORTANT:

To ensure this product is installed properly, you must
read and follow these guidelines.
 This product must be installed by a professional
licensed contractor.
 The owner/user of this product must keep this
information for future reference.
 Be sure your installation conforms to all federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
 Inspect the product to ensure you have all the parts
required for proper installation.
 Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
 DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
 Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
 This product requires 4 holes on the mounting
surface. The spout requires 2, 1” (25mm) diameter
holes with a 7-7/8” (200mm) on-center spread. The
spray and control valve require a 1-1/4” (32mm)
diameter hole each. There is no required on-center
spread for the control valve and spray.
SPOUT INSTALLATION:
1. Remove the SUPPLY NUTS, MOUNTING NUTS, METAL
WASHERS and RUBBER WASHERS from the SPOUT.
Do
NOT remove the RUBBER WASHERS beneath the
ESCUTCHEONS. See FIGURE -01.
FIGURE – 01
MOUNTING
NUT
SUPPLY
NUT
METAL
WASHER
RUBBER
WASHER
ESCUTCHEON
MOUNTING
NUT
SUPPLY
NUT
METAL
WASHER
RUBBER
WASHER
ESCUTCHEON