Waterworks Universal Modern One Hole High Profile Kitchen Faucet, Metal Lever Handles and Spray - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
UNIVERSAL
One Hole Modern Kitchen Mixer with Spray
INSTALLATION GUIDELINES
Page 1 of 2 12.21.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
UNIVERSAL ONE HOLE KITCHEN MIXER AND SPRAY (STYLE # UNKM10).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Style No. UNKM10
SPECIFICATIONS:
Fitting Hole Diameter: 1-1/2"
Inlet Connection Size: 9/16"
Inlet Connection Type: Female Straight Thread
Maximum Deck Thickness: 2-3/16"
Minimum Deck Thickness: 1/4"
Recommended Water Pressure: 45psi
Spout Reach: 9-13/16"
Spout Swivel: Yes
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Product should be on-site prior to rough-in. This
allows the installer to visualize the installation and
verify the center spread.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on deck fittings. Upper and lower
washers are provided.
SPOUT INSTALLATION:
¾ See Figure 1 & Figure 3. for Steps 1-5.
1. Remove the diverter assembly from the outlet and
return hoses. Remove the rubber washer, metal
washer & nut from the spout assembly's threaded
shank.
2. Place the spout assembly through hole in the deck,
along with the hoses, making sure the rubber washer
in between the spout and surface.
3. Re-install rubber washer, metal washer and nut from
under the deck.
4. Tighten the nut up against the bottom of the
mounting surface to secure the spout assembly.
5. Attach the return hose to the 1/2" port on the
diverter assembly. Attach outlet hose to the 3/8"
port on the diverter assembly.
Figure - 01
RUBBER
WASHER
METAL
WASHER
NUT
HOT
SUPPLY
HOSE
COLD SUPPLY
HOSE
RETURN HOSE
DIVERTER
ASSEMBLY
OUTLET
HOSE
RUBBER
WASHER
AERATOR
SPOUT
ASSEMBLY