Installation guidelines – Waterworks .25 One Hole High Profile Bar Faucet, Metal Handle User Manual
Page 2
PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
.25
One Hole High Profile Bar Faucet with Metal Lever Handle
Installation Guidelines
Page 2 of 2
Rev - 01
10.31.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 ONE HOLE HIGH PROFILE BAR FAUCET WITH METAL LEVER HANDLE (STYLE No. PTKM30, PT30KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
3. Re-install the RUBBER WASHER, METAL WASHER and
MOUNTING NUT. Securely tighten the MOUNTING NUT
to secure the SPOUT to mounting surface.
4. Connect the ADAPTERS from the HOSES to the water
supplies making sure the O-RINGS are inside the
ADAPTERS. See FIGURE – 02.
FIGURE - 02
5. Connect the HOSES to the ADAPTERS making sure
they are not pinched or kinked.
FINISH AND INSPECT THE INSTALLATION:
6. Remove the AERATOR from the SPOUT using the
TOOL provided then open the hot and cold supplies
and carefully operate the HANDLE to flush out any
debris in the supply lines.
7. Inspect all connections for leaks.
8. Shut the water off and re-install the AERATOR.
SERVICING THE PRODUCT:
Refer to FIGURE – 03 for steps 9 & 10.
9. To remove the SPOUT, loosen the SET SCREW behind
the SPOUT then pull the SPOUT up to remove.
10. To access the CARTRIDGE, loosen the SET SCREW
beneath the HANDLE, pull the HANDLE off, unthread
the GLAND COVER then unthread the RETAINING
COLLAR to expose the CARTRIDGE.
If further assistance is required, please contact Product
Support at 1-800-927-2120 Ext 2 Monday through
Friday, 8am - 6pm EST.
* Putty contains oil and can cause permanent
discoloration on certain materials such as marble,
granite and any porous surface.
O-RING
ADAPTER
O-RING
ADAPTER
FIGURE - 03
.
RETAINING
COLLAR
SPOUT
SET SCREW
SET SCREW
GLAND COVER
HANDLE
RETAINING
COLLAR
SPOUT
SET SCREW
SET SCREW
GLAND COVER
HANDLE