Waterworks Henry One Hole Bar Faucet , Metal Cross Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
HENRY
One Hole Bar Faucet with Metal Cross Handle Installation Guidelines
Page 1 of 2
Rev - 01
10.16.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
HENRY ONE HOLE BAR FAUCET WITH METAL CROSS HANDLE (STYLE No. HNKM40, HN40KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. HNKM40†
SPECIFICATIONS:
Deck Thickness Maximum: 1-1/4” (32mm)
Fittings Hole Diameter: Ø1-3/8” (35mm)
Handle Turn Angle: Half Turn
Inlet Connection Size: 3/8”
Inlet Connection Type: Compression Connection Hoses†
Restricted Maximum Flow Rate: 2.2gpm (8.3liters/min)
Spout Reach: 5-1/4” (133mm)
Spout Swivel: No
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
† UK Style No.
HN40KM is supplied with 2 BSP adapters,
assembly required.
IMPORTANT:
¾ To ensure this product is installed properly, you must
read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference..
¾ This product must be installed by a professional
licensed contractor.
¾ Be sure your installation conforms to all federal, state,
and local codes.
¾ In the State of Massachusetts, all installations must
comply with the rules and regulations set forth within
248 CMR.
¾ Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
¾ Inspect the product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
¾ NOTE: The screw on the top of the handle is purely
aesthetic. DO NOT REMOVE.
INSTALLATION:
1. Remove the NUTS, METAL WASHER, and UPPER
RUBBER WASHER from the THREADED RODS. See
FIGURE - 01.
NUTS
SPOUT
ASSEMBLY
AERATOR
REMOVAL
KEY
METAL
WASHER
LOWER
RUBBER
WASHER
INLET
SUPPLY
HOSES
THREADED
RODS
UPPER
RUBBER
WASHER
FLOW
RESTRICTING
AERATOR
NUTS
SPOUT
ASSEMBLY
AERATOR
REMOVAL
KEY
METAL
WASHER
LOWER
RUBBER
WASHER
INLET
SUPPLY
HOSES
THREADED
RODS
UPPER
RUBBER
WASHER
FLOW
RESTRICTING
AERATOR
FIGURE – 01
2. Ensure that the INLET SUPPLY HOSES and
THREADED ROD are securely tightened to the SPOUT
ASSEMBLY, then insert the HOSES and THREADED
RODS through the Ø1-3/8” (35mm) hole on the
mounting surface making sure the UPPER RUBBER
WASHER is beneath.