Waterworks Regulator One Hole Low Profile Bar Faucet, Metal Wheel Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
REGULATOR
One Hole Low Profile Bar Faucet with Metal Wheel Handle Installation Guidelines
Page 1 of 2
Rev - 01
10.9.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
REGULATOR ONE HOLE LOW PROFILE BAR FAUCET WITH METAL WHEEL HANDLE
(STYLE No. RGKM01, RG01KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
STYLE No. RGKM01†
SPECIFICATIONS:
Deck Thickness Maximum: 2-1/16” (53mm)
Fittings Hole Diameter: Ø1-3/4” (44mm)
Handle Turn Angle: Quarter Turn
Inlet Connection Size: 3/8”
Inlet Connection Type: Compression Connection Hoses†
Restricted Maximum Flow Rate: 2.2gpm (8.3liters/min)
Spout Reach: 8-1/4” (210mm)
Spout Swivel: Yes
Water Pressure Minimum: 20 psi (1.4 Bar)
Water Pressure Maximum: 80 psi (5.5 Bar)
Water Pressure Recommended: 45 psi (3 Bar)
† UK Style No.
RG01KM is supplied with 2 BSP adapters,
assembly required.
IMPORTANT:

To ensure this product is installed properly, you must
read and follow these guidelines.
 The owner/user of this product must keep this
information for future reference..
 This product must be installed by a professional
licensed contractor.

Be sure your installation conforms to all federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.

Refer to the specification and assembly drawings
attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.
 Inspect the product to ensure you have all the parts
required for proper installation.

Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.

DO NOT use putty. Putty contains oil and can cause
permanent discoloration on certain materials such as
marble, granite and any porous surface.
INSTALLATION:
1. Remove the NUT, METAL WASHER, and RUBBER
WASHER from the SHANK as shown in FIGURE - 01.
Do
NOT remove the O-RING beneath the
ESCUTCHEON.
FIGURE – 01
2. Ensure that the SUPPLY HOSES are securely tightened
to the VALVE BODY, then insert the SHANK through
the Ø1-3/4” (44mm) hole on the mounting surface
making sure the O-RING is beneath the ESCUTHCEON.
 NOTE: The SPOUT can be installed with the HANDLE
on either the right or left side. The SPOUT can swivel
to work in both positions.
3. Re-install the RUBBER WASHER, METAL WASHER
and NUT and securely tighten the NUT to secure the
SPOUT to mounting surface.
NUT
METAL WASHER
RUBBER WASHER
HOSE "BLUE"
HOSE "RED"
SHANK
ESCUTCHEON
NUT
METAL WASHER
RUBBER WASHER
HOSE "BLUE"
HOSE "RED"
SHANK
ESCUTCHEON