Waterworks Boulevard Volume Control Valve Trim with Metal Cross Handle - Manual

Boulevard Cross Handle Wall Valve And Trim
11/02 W A T E R W O R K S

These guidelines have been prepared for the professional contractor to aid in the installation of:
BOULEVARD CROSS HANDLE WALL VALVE AND TRIM
(GUSV12R & BDSV47)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
Installation Guidelines
1
NOTES:
➢ Use only a protected, smooth-jawed, or strap wrench on any finished
surface.
ROUGH-IN:
➢ Install the valve with the water flowing in the direction indicated.
➢ IMPORTANT:Valve rough-in is 2 1 ⁄ 2 " from the centerline of the supplies
to the face of the finished wall.
➢ Separate supply stop valves, which will facilitate servicing should be
installed in an accessible location.
FINISH:
➢ Screw on trim and measure from the base of the escutcheon to the
finished wall. Remove the trim and retain this measurement.
➢ Cut the valve stem and threaded sleeve so that the trim becomes flush
with the finished wall.
➢ The amount cut from the valve stem and threaded sleeve should be the
same as the distance measured in the previous step.
➢ Reattach the trim and check to ensure it is flush with the finished wall. If
necessary, cut the valve stem and threaded sleeve further to make flush.
➢ Carefully turn on the water supply and check all connections for leaks.
➢ If further assistance is required, please contact Product Support at
1-800-927-2120 (8am-7pm EST).
1 ⁄ 2 "
2 1 ⁄ 8 "
3"
11 ⁄ 16 "
2 1 ⁄ 2 "
ø 2 1 ⁄ 2 "
Note: 3 ⁄ 4
" NPT
GUSV12R (rough) & BDSV47 (trim)
Figure 1
Handle Escutcheon Valve
Threaded Sleeve Valve Stem