Waterworks Easton Vintage Thermostatic Control Valve Trim with Metal Lever Handles - Manual

INSTALLATION GUIDELINES:
Easton ® Concealed Thermostatic Valve Trim
with Lever/Cross Handle (Classic & Vintage)
These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON ® CONCEALED THERMOSTATIC VALVE TRIM
WITH LEVER/CROSS HANDLE (Classic & Vintage)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
Installation Guidelines
1
W A T E R W O R K S
5/06
VINTAGE
EASV16(cross handle)
EASV17-K (all metal lever handle)
EASV18-K (white porcelain lever handle)
5 7 /
8
"
Note:
• Ideal operating pressure is 50-60 psi
• Rough in depth is 2 1 /
2
"
• Max pressure is 80 psi, Min pressure is 25 psi
•
3 /
4
" female NPT
2 7 /
16
"
4 13 /
16
"
2 1 /
2
"
3"
3"
3 1 /
2
"
EASV17-K EASV18-K,
4"
3" 1"
2 3 /
4
"
3 1 /
8
"
CLASSIC
EASV06(cross handle)
EASV07-K(all metal lever handle)
EASV08-K(white porcelain lever handle)
Note:
• Ideal operating pressure is 50-60 psi
• Rough in depth is 2 1 /
2
"
• Max pressure is 80 psi, Min pressure is 25 psi
•
2 7 /
16
"
4 13 /
16
"
2 1 /
2
"
5 7 /
8
"
3"
3 1 /
2
"
EASV07-K
EASV08-K
3"
4"
3" 1"
2 3 /
4
"
3 1 /
8
"
IMPORTANT
To ensure this product is installed properly, you
must read and follow these guidelines.
The owner/user of the valve must keep this
information for future reference.
This valve includes integrated service stops. Make
sure the tile guard is in place.
This valve features anti scald protection.The risk
of scalding exists until the installer has properly
calibrated/adjusted the temperature setting
during final trim installation.
Valve body rough-in depth is 2 ½" the centerline of
the inlets to the face of the finished wall.
Be sure your installation conforms to local codes.
This thermostatic valve only mixes hot and cold
water and does not have volume control or shut
off capability. A diverter or wall valves (provided
separately) control on/off/volume and must be
installed for each fitting that will have water flowing
to it.
This product must be installed by a professional
contractor.
Refer to the specification and assembly drawings
attached. Valves are sold partially assembled but
hown fully disassembled for illustrative and service
purposes only.
If soldering any connections, remove cartridge to
prevent damage to seals and internal assembly.
The trim should be on-site prior to rough in and
allows the installer to visualize the installation.
Inspect this product to assure you have all parts
shown that are required for proper installation.
Check incoming water pressure; ideal operating
pressure is 50-60 psi. The minimum is 25 psi. and
the maximum is 80 psi.
Inlets:
3 /
4
" female NPT Inlets: