Waterworks Universal Three Way Thermostatic Diverter Valve Trim - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
UNIVERSAL
Diverter Plates for Pressure Balance and Thermostatic Shower Systems
INSTALLATION GUIDELINES
Page 1 of 1 7.19.2013
These guidelines have been prepared for the professional contractor to aid in the installation of:
UNIVERSAL DIVERTER PLATES FOR PRESSURE BALANCE & THERMOSTATIC SHOWER SYSTEMS
(STYLE #'S UNDV2P, UNDV2T, UNDV3P & UNDV3T).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Two Way Pressure Balance
Style No. UNDV2P
Two Way Thermostatic
Style No. UNDV2T
Required Valve
Style # GUDV23
(SOLD SEPARATELY)
Required Valve
Style # GUDV14
(SOLD SEPARATELY)
Three Way Pressure Balance
Style No. UNDV3P
Three Way Thermostatic
Style No. UNDV3T
Required Valve
Style # GUDV65
(SOLD SEPARATELY)
Required Valve
Style # GUDV66
(SOLD SEPARATELY)
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product must be installed with a Two or Three
Way Diverter Valve (SOLD SEPARATELY) & Handle
Trim (SOLD SEPARATELY). Please refer to the
specific valve & specified handle trim installation
guidelines for rough-in requirements.
¾ This product is supplied with a Plastic Insert that
may be removed if the Handle Trim Adapter does
not fit through it.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor and must be onsite prior to
rough-in, this allows the installer to visualize the
installation.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ DO NOT use putty on fittings.
TRIM PLATE INSTALLATION:
¾ See Figure - 01 for Steps 1-3.
¾ Diverter valve must be roughed-in & finished wall
must be complete prior to trim plate installation.
1. Follow the installation guidelines for the specific
handle trim used for proper cuts to be made to
threaded tube and stem of cartridge.
2. After the proper cuts have been made, slide diverter
plate over the modified diverter valve components.
3. Hold plate against the wall, making sure the foam
gasket is behind it. Thread & tighten handle trim
onto the threaded tube, making sure the handle is
aligned. Note: Discard the plastic insert if the handle
trim does not fit through it.
Figure - 01
HANDLE TRIM ASSEMBLY
[SOLD SEPARATELY]
FINISHED WALL
DIVERTER PLATE
PLASTIC INSERT
FOAM GASKET
DIVERTER VALVE
THREADED TUBE
& CARTRIDGE STEM
[SOLD SEPARATELY]
¾ If further assistance is required, please contact
Product Support at 1-800-927-2120 (8am-6pm EST).