Waterworks R.W. Atlas Exposed Thermostatic Valve with Metal Lever Handles - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
RW ATLAS
Exposed Thermostatic Valve
INSTALLATION GUIDELINES
Page 1 of 4 8.10.2012
These guidelines have been prepared for the professional contractor to aid in the installation of:
RW ATLAS EXPOSED THERMOSTATIC VALVE WITH METAL WHEEL HANDLE (STYLE# RWXS01)
& METAL LEVER HANDLE (STYLE # RWXS10)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM
Metal Wheel Handle
Style No. RWXS01
Metal Lever Handle
Style No. RWXS10
SPECIFICATIONS:
Connection Type:
3 /
4
" Copper Compression
Inlet Spread: 11 1 /
2
" MIN - 11 3 /
4
" MAX
Outlet Spread (From Inlets): 5 7 /
8
" MIN - 6" MAX
Recommended Pressure: 45 psi
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines.
¾ The owner/user of this product must keep this
information for future reference.
¾ This product is supplied with the Waterworks
Universal Thermostatic Valve (STYLE # GUTH37)
which features anti-scald protection. The risk of
scalding exists until the installer has properly
calibrated/adjusted the temperature setting during
final trim installation. Refer to the Installation
Guidelines of the thermostatic valve for additional
information.
¾ Be sure your installation conforms to federal state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This exposed thermostatic valve only mixes hot and
cold water. It does not have volume control or shut-
off capabilities. A diverter or wall valve (sold
separately) control on/off/volume and must be
installed for each fitting that will have water flowing
to it. This valve cannot be used directly with a
diverting tub spout.
¾ This product must be installed by a professional
licensed contractor and must be onsite prior to
rough-in, this allows the installer to visualize the
installation.
¾ Proper blocking in the wall is required.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ Install accessible hot and cold service stop valves to
facilitate servicing.
¾ DO NOT use putty on fittings.