Waterworks .25 Handshower On Hook with Metal Handle - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 04.11.07
.25 Handshower On Hook
PTHS25
These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 HANDSHOWER ON HOOK (PTHS25) All dimensions are based on origin specification and are
subject to change and variation. Please consult your Design Associate for current specifications.
1 1
4
"
2 3
8
"Ø
2 3
4
"
IMPORTANT
To ensure this product is installed properly, you must
read and follow these guidelines.
The owner/user of this product must keep this
information for future reference.
The risk of scalding exists until the installer has
properly calibrated the temperature setting on the
thermostatic valve (sold separately).
Observe all local plumbing and building codes.
Product uses dual check valves for backflow
prevention. Local plumbing codes may require a
vacuum breaker to be installed in-line to handshowers.
Please consult with local plumbing codes.
A wall valve (sold separately) controls on/off/volume
and must be installed for proper operation of this
product.
This product must be installed by a professional
contractor.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface
ROUGH IN:
1. Install a wall valve (sold separately) at the desired
location.
2. Determine the ideal location of the inlet/hook
assembly based on the clients preference.
3. Finish the rough in by installing a well supported 1
2
"
female ips elbow.
4. Sweat a piece of 1
2
" copper pipe of appropriate length
onto a 1
2
" male x 1
2
" sweat adapter. Thread the
copper and adapter assembly into the female elbow in
the wall. The copper must protrude 1" from the
surface of the finished wall
ELBOW/HOOK INSTALLATION:
1. Unpack the hook/elbow (5) and verify the adapter (1)
is threaded completely into the hook/elbow.
2. To verify alignment of the hook/elbow and adapter,
make a mark at 12:00 that extends from the
hook/elbow onto the adapter.
3. Unthread the adapter from the hook/elbow then slide
the adapter onto the copper. The face of the adapter
should NOT extend more than 1 1
4
" off the face of
the finished wall.
4. After verifying fit, make sure the mark made in step 2
remains at 12:00 then sweat the adapter onto the
copper. If it is not aligned, the hook/elbow will not
thread on completely and cause a leak or not align
properly so the elbow/hook points down at 6:00.
5. Allow the adapter to cool then slide the escutcheon
onto the adapter.
6. Thread the hook/adapter onto the adapter making
sure the washer (4) is in place
7. Install the hand shower hose and verify proper
function. A flow restrictor is located in the base of
the hand shower.
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).