Waterworks Julia Handshower On Bar with White Porcelain Handle - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 10.06.06
Julia Handshower on Bar
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA HANDSHOWER ON BAR (JUHS01-K, JUHS02-K, JUHS03-K) All dimensions are
based on original specification and are subject to change and variation. Please consult your Design
Associate for current specifications.
IMPORTANT
To ensure this product is installed properly, you
must read and follow these guidelines.
The owner/user of this product must keep this
information for future reference.
Be sure your installation conforms to local codes.
A wall valve or diverter valve (sold separately)
controls on/off/volume and must be installed for
proper operation of this product.
This product must be installed by a professional
contractor.
Refer to the specification and assembly drawings
attached. This product is sold partially assembled
but shown fully disassembled for illustrative and
service purposes only.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface
ROUGH IN:
1. Install a wall valve or diverter valve(sold separately) at
the desired location.
2. Finish the rough in by installing a well supported 1
2
"
female IPS elbow.
3. Determine the ideal location of the bar assembly
based on the clients preference and install wood
blocking or position over a stud to properly secure
the bar.
BAR AND ELBOW INSTALLATION:
4. The inlet elbow (2) is 1
2
" female IPS; install the elbow
using a nipple of appropriate length.
5. Drill holes at the proper spread of 23 5
8
" to
accommodate the screw anchors (7c) and bar
mounting screws (7a).
6. Remove the cap (7) from each bar end (7b), thread
the screw (7a) into the wall then reinstall the cap.
7. Install the hand shower onto the conical end (4b) of
the hose
8. To adjust the angle of the hook, loosen the nut (5h).
9. To adjust the height of the hook, loosen the knob (5).
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).
4 7
8
"
2 3
4
"Ш
2 1
4
"Ш
2 1
4
"Ш
23 5
8
"
2 1
4
"
JUHS01-K (metal handle)
JUHS02-K (white porcelain handle)
JUHS03-K (black porcelain handle-MTO)