Waterworks Formwork Deck Mounted Exposed Tub Filler with Handshower and Metal Joystick Handle - Manual

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Single Hole Deck Mounted Tub Fillers
INSTALLATION GUIDELINES
Page 1 of 4 4.17.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK DECK MOUNTED EXPOSED TUB FILLER (STYLE# FMXT30) AND DECK MOUNTED
EXPOSED TUB FILLER WITH HANDSHOWER (STYLE# FMXT50)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Style No. FMXT30
Style No. FMXT50
SPECIFICATIONS:
Fitting Hole Diameter: Ø1-1/2"
Inlet Connection Size: 1/2"
Inlet Connection Type: Female Hose Connection
Deck Thickness: 1/4" MIN - 1-5/16" MAX
Water Pressure: 20 psi MIN - 80 psi MAX
Recommended Water Pressure: 45 psi
Restricted Maximum Flow Rate: 2.5 gpm
(FMXT50 Handshower)
IMPORTANT:
¾ To ensure this product is installed properly, you
must read and follow these guidelines. The
owner/user of this product must keep this
information for future reference.
¾ Be sure your installation conforms to federal, state,
and local codes. In the State of Massachusetts, all
installations must comply with the rules and
regulations set forth within 248 CMR.
¾ This product must be installed by a professional
licensed contractor.
¾ Inspect this product to ensure you have all the parts
required for proper installation.
¾ Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface.
¾ The use of certain plumber's putty may stain stone
or tile surfaces.
¾ An access panel must be installed for servicing and
installation.
¾ Install accessible hot and cold service stop valves to
facilitate servicing.
¾ Note: The FMXT50 handshower works
independently of the tub spout. Hot & Cold
connections must be made to both the tub spout
and handshower control separately.
SPOUT INSTALLATION:
SPOUT ASSEMBLY
NUT
METAL WASHER
RUBBER WASHER
SUPPLY HOSES
SPOUT SHANK
RUBBER GASKET
SPOUT ASSEMBLY
NUT
METAL WASHER
RUBBER WASHER
SUPPLY HOSES
SPOUT SHANK
RUBBER GASKET
FIGURE - 01