Waterworks Universal Pop-up Waste and Overflow Drain - Manual (Page 2)

Waterworks ® Waste and Overflow
Installation Guidelines
W A T E R W O R K S Æ
03/04
These guidelines have been prepared for the professional contractor to aid in the installation of:
WATERWORKS
® WASTE AND OVERFLOW (FDWO51)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
15. Use zip-ties or adequate tape to secure the cable(32) to the
overflow pipe and waste body. Failure to complete this step
will prevent the drain from functioning properly.
16. Install the tail piece(13) onto the tee.
17. Place the overflow cover(25) onto the overflow stem at the
proper position and then tighten the 2mm set screw(26) on
the overflow cover.
18. Place the stopper(9-12) in the waste flange, rotate the
overflow cover clockwise to open the drain, and then verify
there is a
3 /
8
" gap between the stopper(9) and waste
flange(6).To adjust the height of the stopper, turn the
adjustment screw(11) at the base of the stopper and then
tighten the locking nut(10) to maintain the ideal stopper
height.
19. After placing the tub and completing final drain connections
below the floor, close the drain and then fill the tub with
water to make sure the stopper operates and seals properly.
Adjust as required.
➢ If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).
04.08
OPTIONAL PLATED 8" TAILPIECE (ZUPWO01)
8/09