WEATHER GUARD Model 96322-3-01 Mesh Bulkhead, High-Roof, Ford Transit - Manual

24-0324 1 Part no. 24-0324 REV. A
INSTALLATION MANUAL
TRANSIT BULKHEAD — Model Numbers:
96301-3-01, 96302-3-01, 96311-3-01, 96312-3-01, 96321-3-01, 96322-3-01
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
PLAN YOUR VAN (TIPS FOR FASTER INSTALLATION)
 Electric Drill
 Electric Drill-driver or impact wrench
 Pencil or Marker
 Hammer
 Center Punch
 1" Hole Saw
 Hack saw blade or sharp knife
 7/16” and 1/2” Driver Bits and/or Sockets
 Drill Bits: 1/8", 3/8", 1/2”, 13/32”
 Ratchet Drive for your sockets
 Level
 Carpenter’s Square
 Open End Wrenches: 7/16", 1/2", 9/16"
 Installing your Transit bulkhead is very clear cut following these instructions.
 Before cutting or drilling in the floor, verify the location of you gas tank, fuel lines and electrical cables so you don’t acci-
dentally cut something important.
 When mounting to the floor, make sure that the blind fasteners go into the sheet-metal floor. Always wear eye protection
when drilling or cutting.
 When mounting to the B-pillar, you’ll need to cut through the plastic trim in low roof models. A hole saw will give you a nice,
clean edge. Use the 3/8” spacers to ensure a solid mount to the van.
 Your Transit van bulkhead can be up-graded with a swing-door conversion kit, 96901-3-01. If you think you might want to
change to it in the future, put an extra nut between the driver's side panel and the center panel to allow enough space.
DESCRIPTION QTY
BLIND FASTENER 1/4-20 10
BOLT 1/4-20X5/8 HH GR5 16
SCREW 1/4-14x3/4 DRILL 4
NUT LOCK 1/4-20 NYLON 20
WASHER FLAT 1/4'' 40
SPACER FLOOR MOUNTING 6
SPACER FLOOR MNTING 0.5'' 4
BOLT CARR. 1/4-20x5/8 4
TOOL BLIND FAST. INSTALL 1
BOLT 1/4-20x2-1/4'' HEX HEAD 1
BOLT 1/4-20 x 1-1/4 WASH HD 10
BOLT KIT