WEATHER GUARD Model 237 Conduit Carrier User Manual
Page 4
If you have any questions, please give us a call.
Call Toll Free 1-800-456-7865
Weather Guard® products are protected by one or more of the following patents or trademarks:
U.S. - 842268, 1661625, 1663369; Canada - 282725; U.K. - 1400720; other patents pending.
KNAACK
LLC
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, 60014 - 815-459-6020
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
Figure 9.
Body to Crossmember Fastening
Figure 10b.
Installation on a channel
shaped crossmember
8.
Place the Conduit Carrier in position
on the van rack. Install the "U" Clamps
and Clamp Brackets (
see Figure 9.
).
(
See Figures 10a, 10b or 10c for instal-
lation of "U" Clamps and Clamp Brack-
ets for your crossmember
).
7.
Mark the Conduit Carrier where it lays
on the van rack crossmembers. Remove
the Conduit Carrier from the van rack.
Adhere Weatherstripping to the under-
side of the unit where it laid on the
crossmembers (
see Figure 8.
).
Weatherstrip
(cut from bulk)
Figure 8.
Assembly Weatherstripped for Crossmember
"U" Clamp
(2 places)
#12-24 Nylon
Lock Nut
(4 places)
Clamp Bracket
(4 places)
Figure 10a.
Installation on a 211
aluminum crossmember
Figure 10c.
Installation on a square
shaped crossmember
Part No. 24-2370 REV. G ECN 5315 05/13
4
©2000 Knaack LLC